F.u.n.k.e. ATR833A-OLED - Recall a Frequency from the List of the 10 Last Used; Store a Frequency into the User Memory

ATR833A / P/N 833A-(xxx)-(1xx)
Operation and Installation
18
Dokument-Nr.: 01.1411.010.71e / Revision: 3.00
Alternatively, the memory access automatically ends after a timeout, or
can be ended by pressing twice. The former standby frequency has
now been substituted by the frequency selected from the memory.
2.5.4 Recall a Frequency from the List of the 10 Last Used
The radio automatically keeps track of the last 10 used active
frequencies. To access this list, press twice, and select one of the 10
list entries with the turn knob. The selected memory entry
substitutes the former standby frequency.
In the lower left corner of the display, the number of the list entry
selected is indicated by [LST xx] (with xx = 00 … 10).
ACT
123.450
SBY
118.700
LST
01
Key interchanges the newly set standby frequency and the former
active frequency, and leaves the last used list menu.
Alternatively, the list access automatically ends after a timeout, or can be
ended by pressing once. The former standby frequency has now
been substituted by the frequency selected from the memory.
2.5.5 Store a Frequency into the User Memory
The active frequency can be stored into any entry of the user memory.
This is achieved by a long press on when having the user memory
entry to be overwritten selected.
The following example stores the frequency 124.350 MHz of KONSTANZ
into the user memory entry 17:
List entry „00“ contains the last standby frequency from the
MEM menu.
Entry number (Range: 00 – 10)