F.u.n.k.e. ATR833A-OLED - Energy Saving Mode - Automatic Display Darkening

ATR833A / P/N 833A-(xxx)-(1xx)
Operation and Installation
24
Dokument-Nr.: 01.1411.010.71e / Revision: 3.00
A short press of switches to the next configuration item, a long press
of exits the configuration menu.
3.2 Energy Saving Mode – Automatic Display Darkening
In order to save energy – and to extent the lifetime of the OLED display –
an automatic display darkening can be configured.
ACT
123.450
SBY
118.910
DPY
always on
With the rotary knob the following options can be selected:
always on No display darkening at all
xx min off Automatic darkening after xx minutes of user
inactivity (xx = range 1–30)
Reactivation of the darkened display is done by press of any key (except
key ) or turn of any knob (the action of the key pressed is performed
when pressing the key again after the display turned on) or when
transmitting.
This configuration item is not used for selection of 8.33
kHz
or 25 kHz use of a specific frequency, as this
is done by the
ATR833A
automatically depending onto the frequency value
entered.
The interested user may refer to chapter 5
for information
about which frequency values correspond
to which channel
widths.
Please keep in mind to enable 8.33
kHz channel selection
before flying into areas where 8.33 kHz channels are used.