F.u.n.k.e. ATR833A-OLED - TST - Test Mode; Master Reset

ATR833A / P/N 833A-(xxx)-(1xx)
Operation and Installation
28
Dokument-Nr.: 01.1411.010.71e / Revision: 3.00
A short press of switches to the next configuration item, a long press
of exits the configuration menu .
3.6 TST - Test Mode
The last option in the setup mode is the test mode. The test mode is
used by maintenance personnel only for factory-internal calibrations.
ACT
123.450
SBY
118.910
TST
mode off
The test mode is activated/deactivated with .
With active test mode, in normal operation of the radio the lower
display line contains some internal parameters, as shown below:
ACT
123.450
SBY
118.910
VOL
03
H423 V56 E22
Any press of exits the configuration menu .
3.7 Master Reset
To reset all configurations back to factory settings, hold both the and
buttons pressed while switching the radio on with .
Acivation of the master reset is done with . After performing the reset,
the confirmation „successfully“ is displayed, and the radio automatically
restarts.
To leave the menu without performing a master reset, press the key
.
For correct microphone sensitivity configuration
, VOX must be
set to 5 previously (for VOX-settings refer to section 0).
Don’t c
are for volume of the headset’s/speakers output during
this configuration, as this is set separately by INT.