F.u.n.k.e. ATR833A-OLED - Dual Watch Operation

ATR833A / P/N 833A-(xxx)-(1xx)
Operation and Installation
20
Dokument-Nr.: 01.1411.010.71e / Revision: 3.00
6. Enter the name
• by changing the selected character
with
, and advancing the selection
with , just as when manually
entering a standby frequency.
ACT
124.350
SBY
124.350
MEM
17
KONSTANZ
7. Store the name
• either with a long press of ,
• or with a long press of .
ACT
124.350
SBY
124.350
MEM
17
KONSTANZ
You can now leave the user memory access by pressing twice or by
waiting for the timeout.
2.6 Dual Watch Operation
The ATR833A comprises one receiver, therefore DUAL-Watch
(simultaneously monitoring two frequencies) is implemented by
alternating automatically between the active and the standby frequency.
With dual watch mode active, basically the standby (lower) frequency is
tuned in, shortly interrupted in regular intervals by tuning in the active
(upper) frequency for a fraction of a second.
Every then detected radio signal on the active (upper) frequency has
priority, and pauses the dual watch monitoring of the standby (lower)
frequency, as long as the reception/transmission continues on the active
(upper) frequency.
Transmissions are always done one the active frequency.
The dual watch mode is activated by pressing , and indicated by a
changing the “SBY” label for the standby frequency to “DW”.
ACT
123.450
DW 135.700
VOL
05
The dual watch mode is deactivated by pressing again, and by any
operations changing either of the frequencies.