In the Alert Ranging mode, an audible beep can be set based on a user defined range. The audible beep can be enabled when in range,
enabled when out of range, or disabled. When the measurement meets the audio range criteria, the meter will send out a continuous beep until
the measurement transitions outside of the audio criteria range or until the Alert Set feature is set to off.
The info box will show “Alert Range: In” if the measurement is inside of the range and “Alert Range: Out” when outside the range. It is
independent of the audible beep setting.
Alert Set Options:
• On/Off
• Modes (Info box “Alert Range: In”, if the measurement is inside of the following ranges):
o Range = select the upper end of the range and the lower end of the range
o Threshold = select < (less than) or > (greater than) and the value to be the transition point
o Tolerance = select center point and plus/minus value
• Audio alert if:
o In range
o Out of range
o None
The mode and the range values must be set before the Alert Set can be enabled.
Once alert ranging is enabled, the following settings/operations cannot be changed: range, units, ac/dc, hold, relative, and zero. Select the
desired settings when the alert range is disabled.
The last Alert Ranging settings will be recalled as long as those settings/operations are not changed.
To Next Page
Loading...
Need help?
General
