The STATUS commands control and query the MEASUREMENT EVENT, OPERATION EVENT and QUESTIONABLE EVENT registers.
:STATus:MEASurement:EVENt?
:STATus:OPERation:EVENt?
:STATus:QUEStionable:EVENt?
Returns the contents of the specified EVENT register, then clears the register contents.
:STATus:MEASurement:ENABle <NRf>
:STATus:OPERation:ENABle <NRf>
:STATus:QUEStionable:ENABle <NRf>
Programs the specified EVENT ENABLE register with the value <NRf>. <NRf> is an ASCII string representing an integer mask.
For instance, a value of 45 decimal is the same as binary 00101101, thus setting bits 5, 3, 2 and 0 in the enable register.
:STATus:MEASurement:ENABle?
:STATus:OPERation:ENABle?
:STATus:QUEStionable:ENABle?
Returns the contents of the specified EVENT ENABLE register.
:STATus:MEASurement:CONDition?
:STATus:OPERation:CONDition?
:STATus:QUEStionable:CONDition?
Returns the contents of the specified EVENT CONDITION register. The EVENT CONDITION register is a realtime register
reflecting the state of the meter at the time of the read. Some conditions could happen very quickly and could be missed by this
query. It is often better to rely on the contents of the EVENT register since it latches the event until cleared by a specific
command.
:STATus:PRESet
Clears all ENABLE registers.
To Next Page
Loading...
