Chapter 3
3 - 2
Using LCD panel functionality
You can configure the LCD panel to meet your needs.
Pausing on a screen
Normally, the screens cycle on the LCD panel at a constant rate. However,
you can push the Check button to toggle the LCD panel between Hold and
Rotate modes. In Hold mode, a single screen displays. The Rotate mode
changes the screen displayed on the LCD panel every four seconds.
Accessing LCD menus
Press the X button to put the LCD component in Menu mode to access the
menus. The buttons Left Arrow, Right Arrow, Up Arrow, and Down Arrow
are functional only when the LCD panel is in Menu mode. For more
information about using the LCD menus, see About the LCD menus, on page
3-3.
Clearing alerts
Press the Check button to clear any alerts on the LCD panel. You must clear
any alerts on the screen before you can use the LCD panel.
To Next Page
Loading...
