FAAC B614 - Basic Programming

B614 37 732998 - Rev.A_DRAFT
Translation of the original instructions
ENGLISH
8. STARTUP
RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
During operation there is a risk of cutting, crushing or the
total loss of hands due to the moving parts inside the box.
If two barriers are installed in the following configura-
tion Master-Slave, before beginning the start up of the
Master, it is necessary to have configured the Slave
barrier (see § 11).
1. Check that the B614 is locked.
2. Power up the plant (Master barrier) . The board
lights up and the display then comes on:
- firmware version (2 digits separated by a dot)
-
SO flashing if a set-up or the automation status is
requested
3. Check the status of the LEDs at rest (see § 12.1).

The BUS 2easy LEDs must be checked after the devices
have been registered.
4. Memorise the remote controls present on the
plant (see § 10.3).
5. Program E614 without performing the set-up.
!
For the barrier to work properly, set the parameter cF
dependent on the beam length.
6. Register the BUS 2easy devices, if they are installed
(see § 10.4).
7. Check the barrier's direction of travel (see § 12.2).
8. Perform the set-up (see § 8.3).
9. If the XBAT 24 battery is being used:
- Cut off the plant's power supply
- Connect the battery XBAT 24
- Switch on power to the system.
8.1 PROGRAMMING
BASIC PROGRAMMING
1. Press and hold down F until the first basic
function appears. (Each function is displayed
as long as F remains pressed).
F
2. Release: the value of the function appears
(default or programmed).
F
3. Use the
+
or
-
button to modify the value.
-
+
4. Press F to confirm the value displayed. Go
to the next function. The modified value
becomes effective immediately.
F
Proceed in the same way for all the functions. The last function
(
St) allows you to close the program.
5. In
St select Y or no using the
+
+/
-
buttons:
Y = save the new program
no = DO NOT save the new program
6. Press F to confirm and close the program. It returns to the
automation system status view.
To exit from the programming mode at
any time:
pressand hold downF and then also
-
to move
directly to
St.
F
+
-