B614 31 732998 - Rev.A_DRAFT
Translation of the original instructions
ENGLISH
!
The installation must comply with Standards EN 12453
and EN 12445.
When working in the box there are risks of cutting,
shearing, crushing hands due to the presence of moving
parts. Until the installation is completed, the partially
installed barrier must always be left blocked and with
the door and upper lid always closed to prevent access
to the electronic parts and the moving mechanical pars.
Never install the beam before fixing the barrier body
and checking it.
Until the installation is complete, never leave the barrier
unguarded with the beam fitted.
Mark off the work site and prohibit access/transit.
If installation is outside, it must be done in good
weather without rain or gusts of wind. If it is raining,
an adequate shelter for the barrier must be made until
the mechanical and electronic installation is complete.
Never manage the barrier by holding the board holder.
6.1 PERSONALISED KEY RELEASE
Work in progress
6. INSTALLING OPTIONAL FEATURES
To Next Page
Loading...
