FAAC B614 - Installing the Barrier Body

10
11
12
B614 19 732998 - Rev.A_DRAFT
19
50 Nm
Translation of the original instructions
ENGLISH
5.3 INSTALLING THE BARRIER BODY
RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
Perform the operations when there is no electrical power.
!
Before you start, make sure that the plinth's concrete
has solidified.
In this phase the barrier must be locked.
Never manage the barrier by holding the board holder.
1. (10) Remove the 4 nuts with washers from
the plate
2. (11) Place the barrier body on the foundation,
at the four fixing points.
!
Be careful not to damage the electrical cable tubes.
3. (12) Fix the body of the barrier in post ion us-
ing a nut with washer on every fixing point of the
foundation.
!
Use the torque wrench to tighten to the torque shown
in the figure.