FAAC E124S - SIMPLY CONNECT; Module Installation and Communication Setup

14
15
E124S 29 532434 - Rev.A
DL1
DL2
DL3
DL1
DL2
DL3
S800H ENC
2EASY
SAFEcoder
DL1
DL2
DL3
DL1
DL2
DL3
MOT1MOT2
DL1
DL2
DL3
DL1
DL2
DL3
MOT2MOT1
2EASY
DL1
DL2
DL3
DL1
DL2
DL3

DL1 DL1

Translation of the original instructions
ENGLISH
BUS 2EASY ENCODER
1. Connect the cables of the encoder to the 2EASY
terminal board.
2. After turning on power to the board, check the LEDs
on each encoder with the leaf stationary:
DL1 lit = encoder powered
DL2 lit = encoder connected to MOTOR1
DL2 off = encoder connected to MOTOR2
L
For each encoder that does not appear to be connected to
the correct leaf, temporarily disconnect the power sup-
ply and invert the 2 wires on the 2EASY terminal board.
3. Register the BUS 2easy devices using the specific
procedure or via SETUP.
8.1 REGISTERING/REMOVING BUS 2EASY
DEVICES
The SETUP procedure registers the BUS 2easy devices
that are connected. Alternatively, you can carry out
the following procedure.
1. With the board powered, go to the
bu function
in basic programming. If there are no devices
registered,
no will appear on the display, otherwise
a segment will be lit.
- Press the
++ and
--
simultaneously for at least 5 s.
- The display flashes, then
Y appears (registration
complete).
2. Release the buttons.
- A lit segment appears on the display. Press the
++ button to check the type of devices registered
(§ Diagnostics).
3. Exiting from programming mode.
To REMOVE BUS 2easy devices that have already been
registered, after disconnecting them, repeat the regis-
tration (or alternatively the SETUP) procedure.
DL2 on = encoder connected to MOT1
DL2 off = encoder connected to MOT2
Correct connections