TM2 ERY 22 A4518_6G40_Rev.A
HOW TO PREPARE THE MOTOR
NB: If you use tubes with a round form, the driving pulley must be fixed to the tube,
and the installation is to be paid by the person who installs the system. For other
tube sections the fitting is optional, but strongly recommended.
1. Insert the adaptor in the nut mating
the groove with the reference notch and
push till they touch.
2. Fix the driving pulley on the motor pin
until the stop pin clicks.
3. Insert the motor fully in the rolling
tube.
STOP RING NUT ADAPTOR
DRIVING PULLEY
STOP RING NUT
1
2
3
EN
To Next Page
Loading...
