FAAC TM2 ERY - Remote Control Memory Clearing; Setting of Additional Remote Controls

TM2 ERY 32 A4518_6G40_Rev.A
SETTING OF ADDITIONAL REMOTE CONTROLS
REMOTE CONTROL MEMORY CLEARING
Up to 15 remote controls can be set, including the light/wind sensor.
Tn: Already programmed remote control
Tx: Additional remote control
It is possible to delete singly all the memorized remote controls. When the last
one is deleted the motor initial condition is restored. The same applies to the
single channels of a multichannel remote control: just select the channel to cancel.
Tn: Remote control to be cleared
Tn
Tn
Tn
Tn
Tx (2 sec)
Tn (2 sec)
+
A B
B
B
+
A B
B
A
EN