TM2 ERY 27 A4518_6G40_Rev.A
SETTING THE FIRST REMOTE CONTROL
This operation can only be performed when the motor is new, or after a total delete
of the memory.
T1: First remote control to be set
During this step, power up only one motor at time!
T1T1 T1 (2 sec)
Every time you connect the power supply to the motor, you have 3 hours to
store the first remote control. After this time, the ability to store the remote
control is disabled. To reset the timer of the function you have to disconnect
and reconnect the power supply to the motor.
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
+
A B
B B
EN
To Next Page
Loading...
