Fagor C A-0623-E - 3.9 Water Connection

3. Installation instructions
>
17
CAUTION: Exhaust gases reach very high temperatures.
Exhaust pipes must provide a hermetic seal. Materials providing thermal stability
up to a temperature of 400°C must be used.
User information
• Exhaust gases can reach high temperatures, therefore hot exhaust gases and hot sheet
metal parts may cause burns.
• Do not place combustible materials on top of the equipment, as this is a fire hazard.
3.9 Water connection
Connect the appliance to drinking water only.
Connect to the water mains at the points
indicated (Fig. 11), using a new set of hoses
supplied by the manufacturer. Old hose
assemblies must not be reused.
The water inlet pressure must be between 200
and 400 kPa (2-4 kg/ cm
2
). 250 kPa is advised.
The water must meet the following properties:
pH:
6.5 - 7.5
Total water hardness:
5 - 10 º fH (French hardness)
Impurities:
Ø < 0.08 mm
7 - 14 º eH (English hardness)
Chlorides:
max. 150 mg/l
9 - 18 º dH (German
hardness)
Cl:
0.2- 0.5 mg/l
Conductivity:
400– 1,000 µS/cm
Fig. 11