15
DDS
HARDWARE
Ref.1310
Shipping
When shipping the unit, do it protected against blows and pack it in its original cardboard box with its
original packing material. If you do not have the original packaging material, pack it as follows:
1. Get a cardboard box whose 3 inside dimensions are at least 15 cm (6 inches) larger than those of
the unit. The cardboard used to make the box must have a resistance of 170 kg (375 lb).
2. Attach a label to the unit indicating the owner of the unit, his address and name of the person to con-
tact, type of unit and serial number.
3. In case of failure, also indicate the symptom and a short description of the failure.
4. Protect the unit wrapping it up with a roll of polyethylene or with similar material.
5. Pad the unit inside the cardboard box filling it with polyurethane foam on all sides.
6. Seal the cardboard box with packaging tape or with industrial staples.
Storage
Store the product only under the allowed ambient conditions indicated here. See this data in chapter 1 of
this manual. Always protect the product against dust and dirtiness.
Recycling
The product is made of various materials that may be recycled and eliminated separately. Get rid of the
product in compliance with local regulations.
- SHIPPING CONDITIONS,
STORAGE AND RECYCLING -
To Next Page
Loading...
Need help?
General
