Signifies that no command is placed in the current Programming Message
A standard MIDI Command will be programmed (CC#, PC#, NOTE ON/OFF,
etc..)
Puts the controller into TUNER DISPLAY mode
Tells the controller that we are beginning a step (or another step) and will
process all the following commands until (1) another step is reached, (2) end
of programming
Sends a SYSEX message—and will process all linked SYSEX messages as well
Will delay processing by [x] milliseconds before continuing the processing
Will jump to the last Preset used prior to currently selected preset
Will change the Active Page to the LAST PAGE prior to the currently active
page
Will change the Active Page to the selected Page
Will immediately trigger another preset after completing the current
processing
Will change and trigger the selected IA Slot to the ON state and process it
Will change and trigger the selected IA Slot to the OFF state and process it
Will Toggle the state of the selected IA Slot and then process it
Will change the Physical Button (if mapped) to the specified color
Will Store the Current Preset # into a memory location (1- 4)
Will recall and process the preset # which is stored in memory located (1-4)
Will immediately trigger the first preset in the currently selected bank
Jump to the defined Global Page
Override the CC# of an expression pedal (1-4), (CC#)
Select Expression pedal, and force the sending of value defined
Send the current expression pedal value of pedal (1-4)
Resends a specific IA-Slot defined (1-60)
Allows you to override Exp Pedal Port (1-4) with a new Midi Chan # (1-16)
Will store the current state (preset, song, etc…) like a camera. Restore later.
Takes a previous Snapshot (command 23) and restores back to snapshot
To Next Page
Loading...