FAMC Mini - Page 26

26
25
EXP Change IA
2
Tells an expression pedal (1-4) programmed as IA trigger to change IA it
controls (1-60)
26
IA Color Change
2
Forces an IA-Slot (1-60) to change to a specific color on the button
27
MTC Activate
0
Forces the LF to act as a Master Time Clock if current song is programmed for
it. The MTC will also locate the song pointer upon starting MTC mode
28
Status #1 Color
1
Sets the Status #1 on 12/12+/Pro+ to a specific color
29
Auto TapTempo
2
Will automatically trigger an IA-Slot(1-60) 4 times at a specific delay (250-
1000 ms). Editor has a BPM->MS conversion utility on the Song screen
30
Resend Initial
IA-Slots
0
Will automatically resend all Initial IA Slots as defined in current Preset
31
STORE SONG
0
Stores the current song being used into a temporary memory
32
RECALL SONG
0
Forces the LF to change Songs to the stored song from command #31
33
CHANGE SONG
1
Forces the LF to change to song (1-254). If in set-list mode- this will switch to
the Song only if its found in the set-list
34
Function Swap
0
For the current page, this command will quickly swap all Function #1 and
Function #2 commands on the current page. This is a toggle command, so
issuing the command again will reverse the process. This ordering will
disappear when the Page is changed or upon power up.
35
EXP Slot2 MIDI
2
Allows Expression port (1-4) to send a second command with midi channel (1-
16). If this command is used and command 36 is not, then a second midi
command will be triggered with this MIDI channel number using the CC#
found in the global settings (or last override command issued)
36
EXP Slot2 CC#
2
Allows Expression Port (1-4) to send a second command with a specific CC (0-
127). If this command is used and command 35 is not, then a second midi
command will be triggered with this CC# using the midi channel found in the
global settings (or last override command issued)
37
EXP Slot2
INVERT
1
Tells Expression Pedal (1-4) Slot2 to use the inverse value of the main
expression pedal programming. This allows one expression pedal to cross-fade
two different effects at the same time. Slot2 will go down while the main effect
goes up, and vice versa.
38
External Sync
0
If connected to an AXE-FX, KEMPER, or other “sync” compatible device, this
command will “force” a re-sync of real-time parameters, effects, and other
preset related items. This will further update the LF+ display to indicated the
real-time state of the sync’d data.
39
Change Map
1
If you need to change the current IA-Map being used programmatically, then