If an IA Slot will utilize STEP commands, then you can create custom names that will show up on the main LCD, and will
also show on the button LCD for the IA Slot. This will come in handy should you have for instance a preset that triggers
a delay effect with 0%, 25%, 50% and 75% mix values. In this example, perhaps your step names would be “DLY: 0%”
for Step 1, “DLY: 25%” for Step 2, “DLY: 50%” for Step 3 and “DLY: 75%” for Step 4. The display will tell you what step
you are on as you trigger the IA Slot. Good labeling goes a long way to keep things simple while you’re performing.
To Next Page
Loading...