How to Install Your Canopy Housing
12
NOTE: This step is applicable after the necessary
wiring is completed.
Ceiling Canopy
Canopy
Screw Cover
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care
not to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
Figure 1
Figure 2
Shoulder Screw
To Next Page
Loading...
Need help?
General
