EasyManua.ls Logo

Fantec R2650 - Page 67

Fantec R2650
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
66 / 73
Question 10. I configured everything correctly, but still cannot get the
wireless network or UPnP function to work.
Answer:
Are you using a firewall such as Norton Internet Security, McAfee Personal
Firewall, Zone Alarm, etc. or even the built-in firewall of Windows XP? (Don’t
forget that Service Pack 2 for Windows XP automatically upgrades your
firewall and turn it on by default)
If you have a firewall, it may need to be configured or have exceptions created
to allow you to see and communicate with the player on the network. To test if
your firewall is preventing network communication (including PING and access
shared folders); try disabling it to see if you can connect. If you can connect
with the firewall disabled, you may need to add the player to the ‘Trusted’ list or
configure the firewall for local intranet access. Worst-case, disable your firewall
long enough to use the player, and then enable it again when done.
Question 11. I am using the 802.11n Wi-Fi dongle with an 802.11n
wireless router, why the speed is still 802.11g 54Mbps rather than
300Mbps?
Answer:
The IEEE 802.11n Draft standard prohibits using high throughput with WEP or
TKIP as the unicast cipher. If you use these encryption methods (e.g. WEP,
WPA-TKIP), your data rate will drop to 54 Mbps. You may contact the Access
Point or router manufacturer to download the latest firmware, or try other
encryption methods (WPA2-AES or WPA2-TKIP), or choose to configure an
unsecured profile, but this option is not recommended.
Question 12. Where can I find .torrent files for BitTorrent download?
Answer:
A lot of torrent sites can be found on the Internet. Please take care of the
contents you’re downloading and their usage, which might cause copyright
infringements and violate the local laws.
Question 13. Why do some supported photo formats, cannot be shown in
the photo function?
Answer:
In the JPEG format there are different modes. The player doesn’t support all
the modes. So you have to change your photo format first as follow:
(1) Use Photoshop to open the photo;
(2) Choose ”File” then “save as” from the menu, as the picture on the left hand
side shows, select the picture format as JPEG, input the file name and click the
“save” icon;
(3) After click on the “save” icon, a new window will appear as the picture on