EasyManua.ls Logo

Faro ALYA - CLEANING; CLEANING OF THE REFLECTING PARABOLAS; CLEANING OF THE HEAD; CLEANING OF ARMS

Faro ALYA
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ALYA INSTALLATION AND USER’S MANUAL - EN
Edition 2.0 Sept 2018 Pag. 23 di 32
6 CLEANING
Warning against danger of wear and corrosion and falling suspended mass
For all metal or plastic parts it is strictly forbidden to use substances that are abrasive,
corrosive, acids, substances containing chlorine or chloride ions, phosforous or
phosphorous ions
Detergents with Trilene base, petrol, white spirit, clorine or similar.
It is forbidden to directly spray any chemical substance on the device.
It is forbidden the use of wet wipes without washing.
6.1 CLEANING OF THE REFLECTING PARABOLAS
Cleaning must be carried out using a soft cloth in cotton or absorbent cotton with ethyl alcohol or the
specific PERFLEX detergent. Water-alcohol based disinfectants are suitable with 70% isopropyl alcohol or
ethanol.
Caution - potential damage or wear on the parabolas
Never spray detergent directly on the parabolas.
Cleaning operations on the parabolas must be carried out wearing gloves, to avoid leaving
fingerprints on the surfaces.
Never use detergents containing surfactants or water-repellents that depositing can leave
streaks. Slight streaking will not prejudice the quality of the light.
Products differing from those suggested could damage the parabolas.
If in doubt, contact FARO customer care.
6.2 CLEANING OF THE HEAD
Cleaning must be carried out using a soft cloth in cotton wetted ethyl alcohol or the specific PERFLEX
detergent. Always squeeze the cloth to remove all the liquid in excess. Water-alcohol based disinfectants
with 70% isopropyl alcohol or ethanol are suitable.
Warning against danger of wear of the plastic and falling suspended weights
Never spray detergent directly on the head.
Do not use detergents-disinfectants containing the following to clean plastic parts:
• Ammonium Hydroxide
• Sodium Hydroxide
• Hydrogen peroxide
• Ammonium Chloride
• Methylene chloride
• Methyl alcohol
• Acids and corrosive substances of all kinds.
Faro tested and suggests the following disinfectants:
Eco Jet-1 (Cattani Group) / Sporekin Plus DS (Ims srl) / Zefirol Quick (Molteni Dental) /
Durr FD366 Sensitive
6.3 CLEANING OF ARMS
Always use a cloth soaked in disinfectant approved to disinfect the surfaces and pass it over. Always
squeeze the cloth to remove all the liquid in excess.
.
Warning against danger of corrosion and mechanical collapse with falling suspended
weights
Never spray chemical substances directly on the arms or joints and their openings.
Do not use detergents-disinfectants containing the following to clean plastic parts:
• Ammonium Hydroxide
• Sodium Hydroxide
• Hydrogen peroxide
• Ammonium Chloride
• Methylene chloride
• Methyl alcohol
• Acids and corrosive substances of all kinds.
Faro tested and suggests the following disinfectants:
Eco Jet-1 (Cattani Group) / Sporekin Plus DS (Ims srl) / Zefirol Quick (Molteni Dental) /
Durr FD366 Sensitive
In case of wrong chemicals are used, rinse the surfaces with water and contact the FARO
Service.

Table of Contents

Other manuals for Faro ALYA