- CONFIGURATION OF SUPPLEMENTARY BUTTONS AND COMBINATION
OF THE ICONS (VIRTUAL BUTTONS)
1. Insert the battery in the radio remote control and switch on electrically the
crane.
2. Push and keep pushed two of the three buttons of supplementary activation
and switch on the radio remote control with the button “ON”. Appears the
inscription “FAVORITE CONFIGURATION” that confirms the entry in the
menu of buttons combination.
3. Move with the rotary selector on the icon requested and push the physical
button 1, 2 or 3 according to the button that you want to combine to that
icon.
4. Repeat the operation to assign the functions of the other two buttons.
5. To confirm the assignment of the buttons functions, it's necessary to
switch off and relight the radio remote control.
The combination physical button/virtual button can be modified at any time simply
repeating all the procedure previously indicated.
- RE-START OF THE RADIO REMOTE CONTROL
If, when switching on the radio remote control after its first activation, problems con-
cerning icon representation on the display appear, proceed in the following way:
1. Switch on the radio remote control panel.
2. Push at the same time the "E" and "H" buttons (fig.9).
3. The radio remote control display will show “updating”.
4. Wait approx. three (3) minutes to allow loading of all the icons on the
display. When the display shows “Icons updated please power off”, switch
off and restart the radio remote control panel.
5. The crane can now be operated.
14.2.3
CONTROLS TO
OPERATE THE CRANE
GR4_5-EVOLUTION
To Next Page
Loading...