VERSION: how to control the software release.
· Select the icon "ENTER" (FX800 will be displayed), select, again,
press the icon repeatedly and then select icon.
· Select the menu "VERSION" by using the icon then select the icon
· The software release (i.e. 02.00 09/06/05) will be displayed; by selec
ting the icon you'll read the graphic version (GUI).
v n n . n n g g / m m / a a
HOW TO CONTROL THE LOAD HOOKED ON MANUAL EXTENSIONS.
When to use the procedure:
The procedure allows to calculate if a load can be moved when using manual
extensions on crane and/or hydraulic jibs.
This procedure give us back the following information:
- YES/NO response about lifting a load (YES if the load weight is smaller
or equal to the maximum applicable load; NO in the opposite case).
- Approximate calculation of the load weight
The procedure can be activated only if:
- The procedure for the use of the manual extensions has been activated
through password.
- The password has been typed in and accepted.
Procedure:
· Start from the main menu and press contemporarily the ENTER and %
buttons.
% 1 2 2 1 3 3
- At this point, if the crane can install manual extensions both on crane
and on hydraulic jibs, the following message will be displayed.
(Note: the bold characters represent non-flashing characters).
C R A N E ? J I B ?
- Select JIB if the manual extensions are mounted on hydraulic jib or CRANE
if they are mounted on crane, by using the "+"button. To confirm the selec-
tion press the ENTER key. The following screen will be displayed.
M 1 M 2 M 3
16.7
CONTROLS TO OPERATE
THE CRANE
GR4_5 - EVOLUTION
To Next Page
Loading...