Fayat Group Dynapac CA25 - Operation - Vibration

Operation - Vibration
02-17-2021 4812325897EN 46
Operation – Vibration
Vibration switch
To activate or deactivate the vibration, activate the
high or low amplitude selector (8).
The operator must activate it by the vibration switch,
located on the underside of the forward-reverse lever.
Vibration – Switching on
Never activate vibration when the roller is
stationary. This can damage both the surface
and the machine.
Engage and disengage vibration using the switch (3)
on the bottom of the forward-reverse lever.
Vibration should only be activated at high or low
speed.
Always switch off vibration before the roller comes to
a standstill.
Fig. Control panel:
8. Amplitude switch.
Fig. Forward-Reverse lever:
3. Vibration switch.
8
3