Fayat Group Dynapac CA25 - Operating Instructions - Summary

Operating instructions - Summary
02-17-2021 4812325897EN 57
Operating instructions - Summary
1. Follow the SAFETY INSTRUCTIONS specified in the Safety Manual;
2. Ensure that all instructions in the MAINTENANCE section;
3. Turn the master switch to the ON position;
4. Move the forward/reverse lever to the NEUTRAL position;
5. Set the manual / static vibration selector to position 0;
6. Set the engine speed switch to idle position (900 rpm);
7. Start the engine and allow it to warm up;
8. Set the engine speed switch to Work mode (2200 rpm);
9. Set the speed control lever to the maximum starting position;
10. Drive the roller. Operate the F/R lever with care;
11. Test the brakes. Remember that the braking distance will be longer if the
hydraulic fluid is cold;
12. Use vibration only when the roller is in motion;
13. In an emergency:
 Press the parking/emergency brake button;
 Hold the steering wheel firmly;
 Brace yourself for a sudden stop.
14. When parking:
 Press the reserve/parking brake button;
 Switch off the engine and block the drum and chock the wheels.
15. When lifting:
 Refer to the relevant section in the Instruction Manual.
16. When towing:
 Refer to the relevant section in the Instruction Manual.
17. When transporting:
 Refer to the relevant section in the Instruction Manual.
18. 20. When recovering:
 Refer to the relevant section in the Instruction Manual.