FCI ST100 series - Parameter Reports; Figure 35 - Example Parameter Report, Group 1; Figure 36

To Next Page

To Previous Page

ST100 Series Conguration Software

Fluid Components International LLC 19

Parameter Reports

A Parameter Reports screen (under Group Parameters in the menu tree) displays the calibration and conﬁguration information saved in the ST100

unit for a particular calibration group numbered 1-5. Selecting a parameter report for a particular calibration group displays that group’s info/data.

Similar to other setup menus there is a Send Changes to Device button to transmit (to ST100) any parameter change. Use of the Send button,

however, is a factory-only operation that requires the Factory level password.

Figure 35 – Example Parameter Report, Group 1

Figure 36 – Example Parameter Report, Group 5

Main Page

Table of Contents3
Introduction5
Installation5
Running the PC Configuration Application5
Figure 1 - USB & Ethernet Connectors on Customer Interface Board (Digital Interface Shown)5
Figure 2 - Welcome Screen6
Figure 3 - Example Process Data Screen6
Configuration Software Basics7
Password Protection7
Figure 4 - Basic Application Screen Elements7
Table 1 - Basic Setup Tabs8
Basic Setup Tab Screens8
Figure 5 - Example Groups Tab (Basic Setup)8
Figure 6 - Example Units Tab (Basic Setup)9
Figure 7 - Example Pipe Size Tab (Basic Setup)9
Figure 8 - Example Alarms Tab (Basic Setup)9
Figure 9 - Example SD Card Logging Tab (Basic Setup)10
Figure 10 - Example Totalizer Tab (Basic Setup)10
Figure 11 - Example Pressure Offset Tab (Basic Setup)10
Table 2 - Advanced Setup Tabs11
Advanced Setup Tab Screens11
Figure 12 - Example User Parameters Tab (Advanced Setup)11
Figure 13 - Example Ethernet Tab (Advanced Setup)12
Figure 14 - Example Data and Time Tab (Advanced Setup)12
Figure 15 - Example Download Calibration Tab (Advanced Setup)12
Configuration Tab Screens13
Figure 16 - Example Reboot Device Tab (Advanced Setup)13
Figure 17 - Example Output Tab (Configuration)13
Table 3 - Configuration Tabs14
Figure 18 - Example 4-20Ma User Tab (Configuration)14
Figure 19 - Example Modbus Tab (Configuration)15
Figure 20 - Example Extended Op. Mode Tab (Configuration)15
Figure 21 - Example Group Switch Setup Tab (Configuration)15
Figure 22 - Example AST Power Mode Tab (Configuration)16
Table 4 - Diagnostics Tabs17
Diagnostics Tab Screens17
Figure 23 - Example Status Tab (Diagnostics)17
Figure 24 - Example Fault Log Tab and Example Fault Log List (Diagnostics)18
Figure 25 - Example Idr Scheduled Tests Tab and Example Idr On-Demand Test Results Display (Diagnostics)18
Figure 26 - Example Idr Test Logs Tab and Example Idr Test Log List (Diagnostics)18
Table 5 - Factory Tabs19
Factory Tab Screens19
Figure 27 - Example Factory Parameters Tab (Factory)19
Figure 28 - Example Identification Tab (Factory)19
Figure 29 - Example 4-20Ma Factory Tab (Factory)20
Figure 30 - Example Options Tab (Factory)20
Figure 31 - Example HART Tab (Factory)20
Figure 32 - Example Memory Tab (Factory)21
Figure 33 - Example Reset Idrs Tab (Factory)21
FE1-FE2 Process Data22
Figure 34 - Example Process Data Screen (FE1)22
Parameter Reports23
Figure 35 - Example Parameter Report, Group 123
Figure 36 - Example Parameter Report, Group 523
Customer Service/Technical Support24

FCI ST100 series - Parameter Reports; Figure 35 - Example Parameter Report, Group 1; Figure 36 - Example Parameter Report, Group 5

Table of Contents

Other manuals for FCI ST100 series

Related product manuals