FeelTech FY6600 Series User Manual

FeelTech
40 FY6600 Series User’s Manual
Troubleshooting
This chapter lists the commonly encountered failures of FY6600 and their
solutions. When you encounter these problems, please solve them following the
corresponding steps below. If the problem remains still, please contact FeelTech
and provide the device information (Press SYS to get it).
Failure Phenomena
Solutions
The screen of the
generator is still dark (no
display) after switch on.
1) Check whether the power is correctly connected.
2) Check whether the power switch has been pulled
in place.
3) Restart the instrument after finishing the above
inspections.
4) If it still does not work correctly, please contact
FeelTech.
CH2 is locked.
1) Check that the signal generator is operating in
synchronous state. Press the SYNC button to enter
the synchronization settings interface to cancel all
synchronization parameters.
2) If the problem is still, please restart the generator.
Set correctly,
but no waveform output
1) Check whether the BNC cable is connected
tightly with CH1 or CH2 connector.
2) Check whether the BNC cable has internal
damage.
3) Check whether the BNC cable is connected
tightly with the test instrument.
4) Check whether the indicators of CH1 or CH2 is
turned on. If not press corresponding button to turn
it on.
5) If the problem is still, please contact FeelTech.

FeelTech FY6600 Series Specifications

General

Brand	FeelTech
Model	FY6600 Series
Category	Control Unit
Language	English