Feelworld L2 PLUS - Connect Computer and L2 PLUS; Turn on Your L2 PLUS

9
2.6 Connect Computer and L2 PLUS
Software control: connect computer and L2 PLUS with CAT6 cable
Record and Stream: connect L2 PLUS’s USB-A and L2 PLUS’s USB 3.0 port with USB3.0 cable
(Note: the color of USB3.0 port is blue)
Minimum System Requirements for macOS
● macOS 11.0 Big Sur or later
● macOS 10.15 Catalina
Minimum System Requirements for Windows
● Microsoft Windows 10 64-bit
2.7 Turn on Your L2 PLUS
The device will enter to the boot interface after turning on .
Note
：
The IP address of the L2 PLUS must be in the same WLAN segment as the computer.
Note: If your computer only has a Type-C port, you can use a USB-A to Type-C cable to transmit the webcam
signal. Please note that the Type-C cable you choose needs to support data transmission. The signal is
recognized in Windows and MAC system as
「
FEELWORLD
」
.