Chapter 5 Feelworld Live Software Operation
Minimum System Requirements for macOS
● macOS 11.0 Big Sur or later
● macOS 10.15 Catalina
Minimum System Requirements for Windows
● Microsoft Windows 10 64-bit
5.1 Connect L2 PLUS and computer
5.1.1 Direct Link via a Network Cable
(1) Modify L2 PLUS’s IP Address
The L2 PLUS is connected to a computer via TCP/IP protocol for data transfer. Therefore, you need to
keep the L2 PLUS on the same IP network segment as your PC or mobile device. If the L2 PLUS is
connected directly to a computer, you need to change the L2 PLUS's IP manually to avoid IP conflicts
on the same network segment.
Steps to modify L2 PLUS’s IP address:
(2) Change the PC’s IP Address
To ensure that the L2 PLUS and the PC can communicate smoothly, the IP address of the computer
needs to be verified.
Note: The IP address of the L2 PLUS must be in the same WLAN segment as the computer or the mobile
control device you choose.
1.Push【MENU】button and enter IP setting menu.
2.Turn OFF DHCP
3.Adjust the value of IP via the knob.
To Next Page