Cut each side of the board in numerical order, you only need to trim off 6mm or so
each time. The numbering works so that the fresh cut face of the board always goes
against the crosscut fence. Continue until you reach number 1 side again and this
time take off approximately 1" / 25mm.
Measure each end of the offcut. If the workpiece does not have the arrow on at this
stage it can easily lead to an incorrect judgement of how the crosscut fence is
presently aligned. See the alignment and adjustments sections for further details of
accuracy.
Check
5-Sided Cut
Make a
How To
To Next Page
Loading...
