How to Make a 5 Sided Cut
Being with a board, ideally 1000mm x 1000mm, preferably of MDF as the chippings
from cutting a board of chipboard can interfere with the result if not done carefully.
You will also need a pair of vernier calipers to accurately measure the off-cut, and a
13mm wrench to adjust the 90° crosscut stop if necessary.
Place the board on the outrigger table against the fence and label each side 1, 2, 3
and 4. Side number one can also be given an arrow to indicate the direction of the
offcut once it is made.
Check
5-Sided Cut
Make a
How To
Adju s t m e n t Lin k Alig nm e nt Lin k
Continued…
To Next Page
Loading...
