Page. 21
8.䎃 Maintenance and Checking䎃
䦟 8-1-2. Zero-point check 䯴ExamZero ppm press Enter䯵
%#76+10
䎃
Ɣ Be sure to clean the sensor before starting the zero-point check.
Ɣ Always prepare mineral water.
Ɣ This may be caused by the dirty detection tube due to aging or contaminated water supplied from the fresh water inlet.
This function is used to check such a stain of the detection tube.
ƔPlease check once a month.
䦟䎃 Zero-point check by feeding mineral water from the upper lid portion (recommended)
5VCPFD[
AAZZZZZZZZZZZZ
Keep on pressing "Esc" for two seconds or longer.
㧷CKP/GPW
%NQEM#FLWUVOGPV
Press "Ÿ" twice.
㧷CKP/GPW
6'56/QFG
Press "Enter.” The TEST mode is set..
Press "Ÿ.”
6'56/QFG
'ZCO<GTQRRORTGUU'PVGT
Press "Enter.” The zero-point check starts.
9CUJVJGKPPGTEGNN
CPFRTGUUGPVGT
Open the upper lid and the drain valve and empty the sensor unit.
Close the drain valve, feed mineral water into the sensor unit, and open the drain valve once
more to empty the sensor unit. Press "Enter.”
䎃
(KNNOKPGTCNYCVGTKPVQ
VJGEGNNCPFRTGUUGPVGT
Repeat a set of feeding mineral water into the sensor unit and draining water from the sensor
unit twice or more. Close the drain valve, feed mineral water into the sensor unit, and close
the upper lid. Press "Enter.”
'ZCO<GTQRRO'UESWKV
AAAAAAAAAAAAAAAAAAAAZZ
Shows a time required until the supplied mineral water becomes stable in the detection tube
(until the oil concentration detector becomes ready to measure the oil concentration).
'ZCO<GTQR R O 'UESWKV
/GCUWTGZZRRO
Measures the concentration of oil in the mineral water.
(You can terminate the measurement anywhere. However, if you do not press the "Esc"
switch for 10 minutes, the oil concentration detector stops measurement.)
Keep on pressing "Esc" for two seconds or longer to stop measurement.
6'56/QFG
'ZCO<GTQRRORTGUU'UE
Press "Enter.”
㧷CKP㨉/GPW
6'56㨉/QFG
"Main Menu" is displayed back.
With this, the zero-point check by feeding mineral water from the upper lid portion is completed.
To Next Page
Loading...