Fema M60-C1 - 2.3 Module RTU; 2.4 Module S4

FEMA ELECTRÓNICA . Series M . M60-C1
23
Protocol Modbus RTU
Funcons implemented 4 (Read_Input_Registers)
Bus type RS-485, up to 57.6 Kbps
Isolaon 1000 Vdc
Slots allowed ‘Opt.1’, ‘Opt.2’, ‘Opt.3’ (see secon 1.23)
Protocol ASCII
Bus type RS-485, up to 57.6 Kbps
Isolaon 1000 Vdc
Slots allowed ‘Opt.1’, ‘Opt.2’, ‘Opt.3’ (see secon 1.23)
The RTU module provides a Modbus RTU communicaons module
for M Series of panel meters. The RTU module implements funcon
‘4’ (‘Read Input Registers’) of the Modbus RTU protocol, to access the
instrument registers (reading value, alarm status, memory of maxi-
mum and minimum, ...)
Conguraon from instrument front keypad, through menu entries
‘Opt.1’, ‘Opt.2’ or ‘Opt.3’, depending on the posion the module is
installed (see secon 1.23).
The RTU module can be ordered pre-installed into a M Series panel
meter, or standalone for delayed installaon, as it does not require
soldering or special conguraon.
2.3 Module RTU 2.4 Module S4
The S4 module provides a RS-485 communicaons module for M
Series of panel meters. ASCII protocol with ‘Master’ / ‘Slave’ archi-
tecture. Addressable with up to 31 modules. Frames codied in rep-
resentable ASCII characters (codes 32 to 255), directly visible using
‘hyperterminal’ or similar programs.
• Congurable for direct retransmission to remote meter of M Se-
ries (20 mm digit height) and BDF Series (60 mm and 100 mm digit
height).
• Access to display values, alarm status, memory of maximum and
minimum, alarm setpoints, ...
Conguraon from instrument front keypad, through menu entries
‘Opt.1’, ‘Opt.2’ or ‘Opt.3’, depending on the posion the module is
installed (see secon 1.23).
The S4 module can be ordered pre-installed into a M Series panel
meter, or standalone for delayed installaon, as it does not require
soldering or special conguraon.
Terminal B B signal from RS-485 bus
Terminal A A signal from RS-485 bus
Terminal G GND
B A G B A G
B A G
Opt.2Opt.1
Opt.3
PowerSignal
Terminal B B signal from RS-485 bus
Terminal A A signal from RS-485 bus
Terminal G GND
B A G B A G
B A G
Opt.2Opt.1
Opt.3
PowerSignal
For more informaon see document 3498_SERIES-M_MODULE-
RTU_i.PDF
For more informaon see document 3499_SERIES-M_MODULE-S4_i.
PDF