Fermax Bruto - Decoder Programming

Pag 43
MDS DIRECT
MDS DIRECT
DECODER PROGRAMMING
Decoders must be programmed with 4-digit codes ranging from 0001 to 9999, to identify each dwelling
in the Residential Zone.
Of these 4 digits, the first 2 correspond to the Block Number where the decoder is installed and the last
2 to the Apartment Number.
NOTE :
9 The first 2 digits corresponding to the telephones connected to any Block Panel must coincide
with that Block Number.
BLOCK 1
123
456
789
A0
MULTIPLEXED DIGITAL SYSTEM
BLOCK 2
123
456
789
A0
MULTIPLEXED DIGITAL SYSTEM
BLOCK 99
123
456
789
A0
MULTIPLEXED DIGITAL SYSTEM
123
456
789
A0
MULTIPLEXED DIGITAL SYSTEM
GENERAL
ENTRANCE
Key in
7
2
%
++
Call 27
Key in
Call 60
++
6 0
%
Key in
1
5
%
++
Call 51
Call 27 to Block 1 -> Key in
7
2
%
++
7
+
1
Block Nº: 01 - Apartment Nº: 27
(initial 0 is not entered)
Call 60 to Block 2 -> Key in
Block Nº: 02 - Apartment Nº: 60
(initial 0 is not entered)
2
++
6 0
%
+
Call 51 to Block 99 -> Key in
Block Nº: 99 - Apartment Nº: 51
1
5
%
++
+
9
+
9
• Programming Options
There are different ways to program the decoders depending on the option selected, as explained
below.
Option ‘3’ from the Main Menu accesses the
Decoder Programming mode.
3
SECONDARY MENU
D1 2 3 4
eInSeCoTel
M1 2 3 4
mCoPaDeCi
MAIN MENU