BLUEHELIX MAXIMA
208 EN
cod. 3541U630 - Rev. 00 - 07/2020
Notes:
1. Parameters with more than one description vary their function and/or range in relation to the setting of the parameter
given in brackets.
2. Parameters with more than one description are reset to the default value if the parameter given in brackets is mo-
dified.
3. The Maximum Heating Power parameter can also be modified in Test Mode.
To return to the service menu, touch the arrow at the top left of the screen.
B08
Hours without DHW draw-
off
0 ÷ 24 hours (time for temporary deactivation of comfort mode
without draw-off)
24
B09 Fault 20 status selection
Deactivated
Enabled
Enabled
B10 Not implemented -- --
B11 Flowmeter timing
Deactivated
1s ÷ 10s (seconds)
Deactivated
B12 Modulation Delta 0 ÷ 30°C/10 0°C/10
B13 Not implemented -- --
B14
Pump antiblock operation
time
0 ÷ 20 seconds 5
B15 Flowmeter type selection
Flow. (450 imp/l)
Flow. (700 imp/l)
Flow (190 imp/l)
Flow (190 imp/l)
B16
Fan frequency in standby
mode
0 ÷ 100% 0%
B17 NOT IMPLEMENTED --
B18
DHW mode activation flow
rate
0 ÷ 100L/min/10 25
B19
DHW mode deactivation
flow rate
0 ÷ 100L/min/10 20
B20 Flue material selection
0 = Standard
1 = PVC
2 = CPVC
0
B21
PVC flue maximum tempe-
rature
60 ÷ 110°C 88°C
B22
CPVC flue maximum tem-
perature
60 ÷ 110°C 93°C
B23
Standard flue shutdown
maximum temperature
60 ÷ 110°C 100°C
B24
PVC flue shutdown maxi-
mum temperature
60 ÷ 110°C 93°C
B25
CPVC flue shutdown maxi-
mum temperature
60 ÷ 110°C 98°C
B26
Flow temperature limit in
automatic calibration
25°C ÷ 55°C 30°C
B27
Maximum temperature
during calibration in DHW
mode
75°C ÷ 95°C 80°C
B28 Flowmeter sensitivity factor 0 ÷ 60 (0 = disabled) 20
B29 Restoring Factory Values Set the value to 10 -
Code Description Range Default
To Next Page
Loading...
