Festo 8079862 - Control Console with Operator Unit TP700 Comfort; Easyport and Fluidlab-PA Closed-Loop V5

Filtration Learning System Setup
© Festo Didactic 696684
37
8.14 Control console with operator unit TP700 Comfort
The control console is mounted on the front right of the profile plate. The 7″ operator unit TP700 Comfort
operates with a resolution of 800 x 480 pixels. The electrical connections with the operating device are
established through a flexible cable bushing. The power supply is provided via a 2-core cable from the
connection board to 24 V DC. The operator unit TP700 Comfort is connected to the controller, for example an
S7-1512C, using a network cable (6 m).
Figure 19: Control console with operator unit TP700 Comfort
8.15 EasyPort and FluidLab-PA closed-loop V5
In addition to control via PLC and operator unit, the Filtration Learning System includes an EasyPort, which is
permanently installed in the 19″ frame. With FluidLab-PA closed-loop V5, process data can be recorded and
evaluated step by step, or the fundamentals of control technology can be learned and developed. The
EasyPort is used to connect a PC to actual hardware.
Figure 20: EasyPort 19″ USB
Optionally, the binary control of the process with the digital technology module or the GRAFCET can be
created in combination with FluidSim.