Festo CPX-FB14 - Table of Contents

Contents and general instructions
III
Festo P.BE-FB14-EN en 1411d English
Table of contents
Intended use VI..........................................................
Target group VII..........................................................
Service VII...............................................................
Instructions regarding this description VIII.....................................
Important user information IX..............................................
1. Installation 1-1...................................................
1.1 General instructions on installation 1-3................................
1.2 Settings of the DIL switches on the bus node 1-8.........................
1.2.1 Removing and mounting the cover for the DIL switches 1-8.........
1.2.2 Settingthe DIL switches 1-9...................................
1.3 Connecting the fieldbus 1-23..........................................
1.3.1 Fieldbus cable 1-23..........................................
1.3.2 Fieldbus baud rate and fieldbus length 1-24......................
1.3.3 Information on connecting the fieldbus 1-25......................
1.3.4 Fieldbus interface 1-27.......................................
1.3.5 Connecting with the fieldbus plug from Festo 1-28.................
1.3.6 Further connection possibilities for the fieldbus with adapters 1-30...
1.4 Bus terminal with terminating resistors 1-33.............................
1.4.1 Install a terminating resistor using the adapters 1-33...............
1.5 Power supply 1-34..................................................
2. Commissioning 2-1................................................
2.1 Commissioning on a CANopen master 2-4..............................
2.1.1 General information on CANopen 2-5...........................
2.2 Configuration 2-6..................................................
2.2.1 Layer setting service (LSS) 2-6................................
2.2.2 LSS commands 2-6.........................................
2.2.3 Configuration of the LSS slave 2-24.............................
2.2.4 Addressing the CPX terminal 2-26..............................
2.2.5 Configuration examples 2-29..................................