Festo CPX-FB38 - Parameterisation Methods

2. Commissioning
2−41
Festo P.BE−CPX−FB38−EN en 0804NH
2.5 Parameterisation
2.5.1 Introduction to parameterisation
The system reaction of a CPX terminal can be largely adapted
to the relevant application. You can individually set the reac
tion of the entire terminal as well as of individual modules
and channels through parameterisation. A distinction is made
between the followingparameterisation functions:
 System parameterisation, e.g. switching off fault
messages, setting reaction times
 Module parameterisation (module− and channel−specific),
e.g. monitoring functions, settings for error handling,
settings for forcing
 Parameterising the diagnostics memory.
A detailed description of the individual parameters as well as
basic information on application can be found in the CPX
system manual (P.BE−CPX−SYS−...).
Which parameters are available for the used modules are
explained in the manual
for the respective module, e.g.
manual for CPX I/O modules (P.BE−CPX−EA−...). An example of
application can be found in section 2.7.
Please note
The CPX terminal is supplied with factory−preset
parameters (default parameterisation).
Please note
Please observe the specific notes on parameterising the
bus node CPX−FB38 in section 2.5.3.