Festo CPX-FB38 - Intended Use

Contents and general instructions
VII
Festo P.BE−CPX−FB38−EN en 0804NH
Intended use
The field bus node type CPX−FB38 described in this manual
has been designed exclusively for use as a slave (I/O device
or Box") in an EtherCAT network.
The CPX terminal must only be used as follows:
as designated in industrial applications
in original condition without modification (only the con
versions or modifications described in
the documentation
supplied with the product are permitted).
in faultless technical condition.
The maximum values specified for pressures, temperatures,
electrical data, torques etc. must be observed.
If additional commercially available components such as
sensors and actuators are connected, the specified limits for
pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Also observe the
standards specified in the relevant chapters,
as well as national and local laws and technical regulations.
Warning
· In order to provide the electric power supply, use only
PELV circuits as per IEC/DIN EN 60204−1 (Protective
Extra−Low Voltage, PE LV).
Take into account also the general requirements for PELV
circuits as per IEC/DIN EN 60204−1.
· Use only power packs which guarantee reliable electrical
isolation of the operating voltage as per IEC/DIN
EN60204−1.