Festo CPX-FB38 - General Prerequisite for Parameterisation

2. Commissioning
2−43
Festo P.BE−CPX−FB38−EN en 0804NH
2.5.2 General prerequisite for parameterisation
Please note
A CPX terminal can only be parameterised if the function
System start with default parameterisation and current
CPX expansion" is activated (set System start" system
parameter accordingly).
With the System start" system parameter, you can
determine the starting reaction of the CPX terminal. Select the
System start with default parameterisation and current
CPX
expansion" setting to permit the required parameterisation.
To perform the parameterisation, use the CPX−FMT or
CPX−MMI. If the parameterisation is not changed, the factory
settings are used.
After parameterisation, you change the setting of the
Systemstart" system parameter to System start with saved
parameterisation and saved CPX expansion". This fixes the
settings and stores
them in the module.
After a new start of the CPX terminal, the bus node diagnostic
LED Modify" (M) lights up permanently. The terminal uses
the saved parameter settings.
Caution
In the case of CPX terminals on which the M LED lights up
permanently, parameterisation will not be restored auto
matically by the higher−order system upon replacement.
In these cases, check before replacement to see which
settings are required and carry out these settings.