Festo DNCB - Tools; Standard Tools; Special Tools; Liability

16 / 17 Festo 7DNCBa_en
7 Tools
This section provides an overview of the tools and aids required to repair the cylinder with piston rod.
7.1 Standard tools
The following standard tools among others are required to repair the cylinder with piston rod:
• Screwdriver
• Wrench
• Flat pliers
• Torque wrench (see tables in the corresponding repair steps for values)
7.2 Special tools
The following special tools are required to repair and service the cylinder with piston rod:
Designation Additional information Available Photo
Push-in sleeve for piston rod
seal
DNCB-32 On request
DNCB-40
DNCB-50
DNCB-53
DNCB-80
DNCB-100
Insertion sleeve for piston rod
seal (only for cylinders with
seals for unlubricated opera-
tion (A3))
DNCB-32
DNCB-40
DNCB-50
DNCB-53
DNCB-80
DNCB-100
Mounting sleeve for piston rod DNCB-32
DNCB-40
DNCB-50
DNCB-53
DNCB-80
DNCB-100
8 Liability
The General Terms and Conditions of Sale of Festo AG & Co. KG, which can be viewed on the Festo website (www.festo.com),
apply.