18
Radio Uconnect
SPEED VOLUME function
(volume change based
on speed)
This function automatically adapts the
volume level to the speed of the car,
turning up the volume when the speed
increases to maintain the ratio with the
noise level inside the passenger
compartment. Press the or
buttons to enable/disable the function.
The display will show
“Speed volume” followed by the
current function status:
❒ Off: function disabled
❒ Low: function enabled
(low sensitivity)
❒ High: function enabled
(high sensitivity).
AUX OFFSET function
(align the portable
device volume with that
of the other sources)
This functions lets you align the volume
of the Aux source, which depends on
your portable player, to that of the
other sources. To activate the function,
press the MENU button and then
select “AUX offset”.
Press the or buttons to decrease
or increase the volume
(set from –6 to +6).
RADIO OFF function
(ON/OFFMODE)
This function lets you choose between
two different radio switch-off modes.
Use the or buttons
to enable/disable the function.
The display will show the chosen
mode:
❒ “00 MIN ”: switch-off depends on
the ignition key; the radio turns off
automatically as soon as you turn
the key to the STOP position;
❒ “20 MIN”: switch-off is independent
of the ignition key; the radio remains
on for up to 20 minutes after you
turn the key to the STOP position.
SYSTEM RESET function
This function is used to restore all
settings to their preset factory values.
The options are:
❒ NO: do not reset;
❒ YES: reset to the default
parameters. During this operation,
the text “Resetting” appears on the
display. At the end of the operation,
the source does not change and
the previous situation will be
displayed.
To Next Page
Loading...
