Fiat PANDA 2017 - External Sources and Bluetooth; USB;iPod and AUX Connectivity

19
Radio Uconnect
RADIO (Tuner)
INTRODUCTION
When the radio is turned on, it will
activate the last source listened to
before it was switched off: AUX,
USB/iPod or Bluetooth
®
.
To select the Radio function while you
are listening to another audio source,
repeatedly press the RADIO button
briefly to select the desired band, FM
AM or DAB (where provided).
Once you have enabled Radio mode,
the display will show the name (RDS
stations only) and the frequency of the
selected radio station, the frequency
band selected (e.g. FM-A) and the
preset button number (e.g. P1).
SELECTING A
FREQUENCY BAND
When Radio mode is enabled,
repeatedly press the RADIO button
briefly to select the desired reception
band.
Each time you press the button, the
following bands are selected cyclically:
❒ FM: FM-A, FM-B, FM-C;
❒ AM: AM-A, AM-B, AM-C;
❒ DAB: DAB-A, DAB-B, DAB-C.
Each band is indicated by the
corresponding text on the display.
The last station selected on the
respective frequency band will be
tuned into.
The FM band is divided into the
following sections:
FM-A, FM-B, FM-C.
PRESET BUTTONS
You can use the buttons numbered
from 1 to 6 to set the following
presets:
❒ 18 in the FM band (6 in FM-A, 6 in
FM-B and 6 in FM-C)
❒ 18 in AM (6 in AM-A, 6 in AM-B e 6
in AM-C)
❒ 18 in DAB (where provided);
To listen to a preset station, select the
desired frequency band and then
briefly press the corresponding preset
button (from 1 to 6).
By pressing the preset button for more
than 2 seconds, the station tuned into
will be stored.
Storing is confirmed by an acoustic
signal.