3
Radio Uconnect
INTRODUCTION
The Uconnect Radio was designed
according to the specific
characteristics of the passenger
compartment, with a customised
design that perfectly matches matching
the style of the dashboard.
The instructions for use are given
below and we recommend you to read
them carefully.
1) 2) 3) 4) 5) 6) 7) 8) 9) 10)
TIPS
Familiarise yourself with the various
radio functions (for example, store the
stations) before starting to drive.
Reception conditions
Reception conditions change
constantly while driving. Reception may
be interfered with by the presence of
mountains, buildings or bridges,
especially when you are far away from
the broadcaster.
IMPORTANT The volume may be
increased when receiving traffic
bulletins.
1)
Care and maintenance
Only clean the cover with a soft, anti-
static cloth. Cleaning and polishing
products may damage the surface.
ANTITHEFT PROTECTION
The radio is equipped with an
anti-theft protection system based on
the exchange of information between
the radio and the electronic control
unit (Body Computer) present on the
vehicle.
This system guarantees maximum
security and avoids the need to enter
the secret code every time the radio
power supply is disconnected.
If the check has a positive outcome,
the radio will start to function, whereas
if the comparison codes are not the
same or if the electronic control unit
(Body Computer) is replaced, the
device will ask the user to enter the
secret code according to the
procedure described in the paragraph
below.
Entering the secret
code
When you turn on the radio, if the
secret code is required, the display will
show the word “Code” for about 2
seconds, followed by four dashes
“- - - -”.
The code is made up of four digits
from 1 to 6, each corresponding to
one of the dashes.
To enter the first digit, press the
corresponding button of the preset
stations (from 1 to 6). Enter the other
code digits in the same way.
If the four digits are not entered within
20 seconds, the display will show
“Enter code - - - -”. If this occurs, it is
not considered an incorrect code
entry.
To Next Page
Loading...
