FieldBee toolbox manual v.1.0
FAQ
Note: Restarting your devices (phone, tablet, FieldBee, Wi-Fi router etc.) will solve most issues.
Why is my FieldBee not visible in the available device list?
In order to set-up/start working with FieldBee, you will need to connect your Android device to FieldBee via Bluetooth.
Please check if FieldBee is fully charged and turned on (by pushing power button or plug in power cable). If FieldBee
has been turned on, then restart, and refresh the searching list.
Important! FieldBee antenna will only remain connected to only one of our apps at a time: FieldBee configuration app
OR eFarmer navigation app. Therefore, it may not be visible in the list of visible devices (or it appears as inactive) if it is
connected to the other app. In this case please close the application that you are no longer using and connect antenna to
the app with which you wish to work: FieldBee app for antenna configuration or eFarmer app for field navigation.
When I turn my FieldBee on, why it is not connecting via Bluetooth?
In this case, your FieldBee antenna most likely has discharged batteries. Please plug in the power cable. You can start
working with the battery charging level of minimum 10%.
Why my FieldBee is not connected to the Wi-Fi?
After entering the password for the selected Wi-Fi network, it may take 20–40 seconds to refresh the Wi-Fi connection
status. If after one minute the status is still NOT CONNECTED, you have possibly entered the wrong Wi-Fi password.
Please try it one more time.
What to do if there is NTRIP server connection problem?
Please check your internet connection. It is necessary to be connected to internet (Wi-Fi, Hotspot) while setting up and
working with FieldBee and NTRIP service.
While working with NTRIP provider, why are there no mountpoints available for selection ?
Mountpoints/correction streams become available automatically after correctly inputting server and port. Please input
server and port in the format: server:port.
For example:
Why is my FieldBee not connecting to NTRIP server?
In order to successfully connect FieldBee to the NTRIP server, please follow the steps:
• Mount FieldBee antenna on the outside of the building under the wide- open sky (to receive satellite coordinates)
• Have Wi-Fi network (or Hotspot) near you
• Connect to Wi-Fi and set up NTRIP server to receive correction.
Why is my Hotspot not visible?
To Next Page
Loading...