FieldBee toolbox manual v.1.0
In order to connect FieldBee to a hotspot, you will need to tap on ALLOW TO USE THE HOTSPOT and then
CHANGE SYSTEM SETTINGS as required. Then tap back arrow, and ENABLE Hotspot. Please remember that
enabled Hotspot turns off Wi-Fi connectivity for your device, but FieldBee will be connected to the internet and will be
ready to set up with NTRIP server.
Why is there no RTK correction for my FieldBee?
If you have a FieldBee Base station at a distance of less than 10 km – please check the FieldBee settings and Base station
settings (connection to Wi-Fi, if base station is correctly selected).
If the distance to base station is more than 10 km, we recommend that you switch RTK mode on your FieldBee to “Use
only Float RTK”. In this case you will have accurate FRTK correction, which will be close to RTK correction. (Please
see page X in FULL MANUAL).
Why can’t I find Base station to connect FieldBee?
There are three probable reasons:
1. Base station is turned off – please press “turn on” button
2. Discharged batteries – please connect base station to the charger.
3. Base station is not transmitting correction – please check if you have a
Wi-Fi connection.
Why is FieldBee not receiving correction but I can see CONNECTED_NTRIP in Status/Summary in Advanced settings?
Your FieldBee might be set up for radio mode. You need to scroll down in the Main Menu and tap button SET
CORRECTION MODE TO Wi-Fi. After applying this setting FieldBee will receive correction.
How long does it take to receive RTK correction?
Receiving RTK correction can take on average 5–15 minutes. It could take up to 30 minutes depending on weather
conditions, distance to the mount point/ base station, and correctly applied settings.
Where can I find battery power level in voltage?
To see the power level in voltage (rather than percentage) you need to go to Advanced settings and open
Status/Summary. There you will find Power Level and also Charger Status.
To Previous Page
Loading...