FireClass FC506 - 3 Key - SW zone; SW zone in WALK TEST

52
Disable
Accessing the DISABLE menu
To access the DISABLE menu from the MAIN screen,
enter the INSTALLER 1 or INSTALLER 2 password.
Each entered digit will be masked with an asterisk
symbol.
The INSTALLER 1 and INSTALLER 2 users can access
all the options described in the user manual. Refer to the
FC503 & FC506 Addressable Fire Control Panels User
Manual for more information.
Both INSTALLER 1 and INSTALLER 2 users can access
option 9 Sounders. Only the INSTALLER 1 user can
access option 7 Password.
7 Key - password (DISABLE)
The password (DISABLE) option is only enabled if you
enter the master INSTALLER PIN in the control panel.
The default PIN is 00000.
The 7 Key is used to select the DISABLE password
option. Select the option to DISABLE or ENABLE the
corresponding password. See Figure 39.
Select the password
In this phase the keypads and the keys have the following
functions:
Alphanumeric keypad
Use the alphanumeric keypad to select the identification
number of the password.
Cursor keys
Table 57: Cursor key functions in select the
password
Key
Function
Up
Show the next type of password
Down
Show the previous type of
password
Right
No function
Left
No function
Note: The types of passwords are User password or
INSTALLER password.
ESC and ENTER keys
Table 58: ESC and ENTER key function in
select the password
Key
Function
ESC
Cancel the operation or return to the
previous screen
ENTER
Confirm the selection
Disable the password
In this phase, the display shows the current status
of the selected User or Installer password. The
possible actions are: ENABLE or DISABLE.
Alphanumeric keypad
No function is related to the alphanumeric keypad.
Cursor keys
No functions are related to the Up, Down, Right,
or Left keys.
ESC and ENTER keys
Table 59: ESC and ENTER key function in
disable the password
Key
Function
ESC
Cancel the operation or return to the
previous screen
ENTER
Confirm the selection and move to the
MAIN screen followed by a panel reset
9 Key- sounders
The sounders option is visible only if you enter the
Control Panel using the INSTALLER 1 (default 00000)
or INSTALLER 2 (default 99999) password. Each
entered digit will be hidden with an asterisk.
Use the sounders option to enable or disable all the
sounders on board or on the loop: SC1, SC2, loop
sounder outputs (SAM, SAB, SNM, AV bases
Symphoni sounders).
Press 1 to enable all sounders: the event ALL
SOUNDERS ENABLED is memorized into the log.
Press 2 to disable all sounders: the event ALL
SOUNDERS DISABLED is memorized into the
log.