FireClass FC600 Series - Page 29

29 Installation Guide Doc. version 2.0
Jumper and DIP switch settings FireClass Panels and Repeaters
Header Function
H1, H2, H3 not fitted Standard operational mode or serial Configuration Download mode.
H1 fitted -
H2 fitted Clear the stored data when the panel is restarted.
H3 fitted Panel configuration download from USB memory stick mode.
Table 8: FC-FI/FC-FI-1 - Header H1, H2, H3 functions
SW6 Sounders activated by
External Alarm
Position 7
[1]
OFF * Disabled
ON Enabled
Table 9: Sounders activated by emergency Alarm setting
* Default
[1] The number 7 is located on the switch, not on the PCB.
SW6 Earth Fault
Monitoring
Position 8
[1]
OFF Disabled
ON * Enabled
Table 10: FC-FI/FC-FI-1 - Earth fault monitoring setting
* Default
[1] The number 8 is located on the switch, not on the PCB.
SW7 RL3 activated by
ALARM
Position 1
OFF * Disabled
ON Enabled
Table 11: FC-FI/FC-FI-1 - RL3 relay activated by ALARM
setting
* Default.
SW7 RL3 activated by FAULT
Position 2
OFF * Disabled
ON Enabled
Table 12: FC-FI/FC-FI-1- RL3 relay activated by FAULT setting
* Default.
SW7 RL4 activated by
ALARM
Position 3
OFF * Disabled
Table 13: FC-FI/FC-FI-1 - RL4 relay activated by ALARM
setting
* Default
ON Enabled
SW7 RL4 activated by FAULT
Position 4
OFF * Disabled
ON Enabled
Table 14: FC-FI/FC-FI-1 - RL4 relay activated by FAULT setting
* Default
SW7 RL4 activated by
ALARM
Position 3
Table 13: FC-FI/FC-FI-1 - RL4 relay activated by ALARM setting
(cont.)
* Default