27
Changing pre-set options
Adjusting your options
1
Enter the Option Adjustment mode (refer to page 26).
2
The diagram below shows how the wash cycle icons relate to the pre-set options you can
change. It also shows what will be displayed when you first enter Option Adjustment mode.
Options you can change are accessible using the HEAVY, HANDWASH, SHEETS and EASY IRON
cycles only.
Use this diagram to help you adjust the options, eg select the HEAVY cycle to modify the wash
temperature, select the HANDWASH cycle to change the out of balance (OOB) recovery process,
and so on.
Wash Temp
OOB Recovery
Factory Reset
EOC Beeps
Fig.18 Option Adjustment mode
3
Use the DELAY START buttons underneath the digital display to scroll through the available
settings of your selected option.
Fig.19 Changing the pre-set options
To Next Page
Loading...
Need help?
General
